Quote:
|
Originally Posted by indy240
I finished building my motor and it's in the car. It ran perfect for my 30 min. break in run, and ran perfect for the mile or two drive i took it on. I fired it up two days later and it seemed like it was missing out a little, not sure why. I'm wondering if the computer will take a little while to learn what i did to my motor and adjust to it. The only thing that should affect a sensor is the cold air intake and the headers. Oh, by the way it's a ka24e. If anyone has any thoughts that may help me it would be appreciated. Thanks
|
If by chance you mean missing = running rough / poor idle, then check the wire running to your Engine Coolant Temperature Sensor. Wiggle the wire connector at the sensor. If your idle clears up & the engine starts to idle normally, then your problem is probably gonna be a bad wire or bad connector. Your ECU uses the signal from the Engine Coolant Temperature sensor to adjust your idle. Check your FSM for an explanation and details as to how it operates.
Anyhow, hope this helps.
ID
95 SE