If you were to do it over again....(s13 Sr) - Page 2 - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

JohnnyDrfiter22 · 12-18-2010, 12:27 PM

what is the purpose of a S14 waterneck?

flossyrobinson · 12-19-2010, 02:27 PM

the purpose of s14 waterneck that is the turbo coolant line hooks up there, making it easier to remove/install when needed. and easier is better right?

i would also look at midmount intercooler instead of front mount i hate how low mine sits... im always worried about it when pulling into parking lot. If you can afford to get a new wiring harness(around $200) do it! it will eliminate alot of guess work when troubleshooting if things dont go as expected.

Get an oil pressure gauge and make sure you prime the engine before you run it, should help you to not spin bearings

Def · 12-19-2010, 03:22 PM

No need for an S14 waterneck, just drill and tap your S13 one and put an NPT to AN fitting in it.

12-19-2010, 03:22 PM	#33
Def Post Whore! Join Date: Apr 2004 Location: Houston, TX Posts: 2,701 Trader Rating: (16) Feedback Score: 16 reviews	No need for an S14 waterneck, just drill and tap your S13 one and put an NPT to AN fitting in it. __________________ S13 Hatch - Goes around tracks quickly DEFSPORT

12-18-2010, 12:27 PM	#31
JohnnyDrfiter22 Zilvia Addict Join Date: Apr 2008 Location: New Jersey Age: 42 Posts: 670 Trader Rating: (0) Feedback Score: 0 reviews	what is the purpose of a S14 waterneck?

12-19-2010, 02:27 PM	#32
flossyrobinson Leaky Injector Join Date: Apr 2007 Location: portland Posts: 78 Trader Rating: (5) Feedback Score: 5 reviews	the purpose of s14 waterneck that is the turbo coolant line hooks up there, making it easier to remove/install when needed. and easier is better right? i would also look at midmount intercooler instead of front mount i hate how low mine sits... im always worried about it when pulling into parking lot. If you can afford to get a new wiring harness(around $200) do it! it will eliminate alot of guess work when troubleshooting if things dont go as expected. Get an oil pressure gauge and make sure you prime the engine before you run it, should help you to not spin bearings