Quote:
Originally Posted by Mr.J
What about just removing a little material from the top of the rack house so that the AN fitting seal properly?
|
Though there is certainly nothing wrong with this approach, it is easier said than done. To remove it to be 100% flush, or even close to that, you will need to set it in a vise, whether for machining or for hand-grinding; and there is no good surface to clamp to for using a mill. You may be able to clamp on to the outlet/inlet ports that feed to the crossover, but then, you will need to remove material by hand since it will be out of tram with the mill.
07-14-2012, 08:07 AM
Threaded Mode