First dyno results after motor swap :) - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Tom Ngan · 09-12-2007, 03:20 PM

Wow seems like everyones torque numbers are so impressive.

Anyway, it tops around 0.4 bar, roughly 5.5 psi.

I got a Blitz R spec boost controller coming in and i'll probably turn up the boost to 1 bar or maybe 1.2 bar. Hoping for something like 300-320rwhp 250lbs of torque on the mustang, then i'll do a dynojet just to see where its at

The megasquirt was laboured on for over a month at the shop, I added my input, but the fine details were done in the shop. Ultimately its something unique, but very time consuming to do when something similar/better can be had from a box ie. haltech/AEM etc

Yea I knew before hand the injectors will be the first limiting factor... might upgrade next season to 740cc.

I really want to push higher boost levels somewhere around 18-20psi, so the IM and the cams really shine, but bit hestiant because its stock bottom end. We will see how the 1 bar pull goes.

Stay tuned for updates, thanks for the reponses everyone.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-12-2007, 03:20 PM	#11
Tom Ngan Leaky Injector Join Date: Nov 2006 Location: x Posts: 102 Trader Rating: (0) Feedback Score: 0 reviews	Wow seems like everyones torque numbers are so impressive. Anyway, it tops around 0.4 bar, roughly 5.5 psi. I got a Blitz R spec boost controller coming in and i'll probably turn up the boost to 1 bar or maybe 1.2 bar. Hoping for something like 300-320rwhp 250lbs of torque on the mustang, then i'll do a dynojet just to see where its at The megasquirt was laboured on for over a month at the shop, I added my input, but the fine details were done in the shop. Ultimately its something unique, but very time consuming to do when something similar/better can be had from a box ie. haltech/AEM etc Yea I knew before hand the injectors will be the first limiting factor... might upgrade next season to 740cc. I really want to push higher boost levels somewhere around 18-20psi, so the IM and the cams really shine, but bit hestiant because its stock bottom end. We will see how the 1 bar pull goes. Stay tuned for updates, thanks for the reponses everyone.