|
|
|||||||
| Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars |
|
|
Thread Tools | Display Modes |
05-21-2006, 03:44 PM
|
#9 |
|
Post Whore!
 |
Fronts are easy as pie. Just bring a hammer, some pliers to remove the cotter pin, a thin flat head to bang out the little cover over the hub nut, then use a 30mm nut on a regular socket wrench with a big breaker bar (I use a 3 foot pole from home depot). Not to mention you need to remove the brakes to take out the hub. You don't need a hub puller.
For the rears, theyre definetly a lot trickier. Just unbolt the bolts holding the hub on from BEHIND the rear spindle. You'll need a big ass breaker bar. You don't need a hub puller (Scott), I just put my spare wheel on the studs... tightened it down, and kicked the tire and BAM... hub falls out. Forgot to mention you need to unbolt the 36mm axel nut for the rears. Sparknotes: Bring Hammer Flat head 14mm, 17mm (to remove brakes) 19mm socket socket wrench 36mm socket 30mm socket (32mm for s14's) Big ass breaker bar Some elbow grease Red Bull |
|
|
| Bookmarks |
|
|
Threaded Mode