can i use this to clean block during headgasket install? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

boosteds13 · 06-05-2007, 12:52 PM

I'd be worried about shrapnel getting into the cylinders/oil passages. When I had my block done, the guy used a CBN cutter or some crap. Wasn't a bad price though as I had the whole bottom end disassembled, cleaned, surfaced and reassembled with new bearings, rings and freeze plugs for around $200 (not including the cost of the rings and main/rod bearings).

Before--

And after--

06-05-2007, 12:52 PM	#1
boosteds13 Zilvia Addict Join Date: Nov 2003 Location: Port Orange, FL Posts: 623 Trader Rating: (0) Rides Gallery: boosteds13 Feedback Score: 0 reviews	I'd be worried about shrapnel getting into the cylinders/oil passages. When I had my block done, the guy used a CBN cutter or some crap. Wasn't a bad price though as I had the whole bottom end disassembled, cleaned, surfaced and reassembled with new bearings, rings and freeze plugs for around $200 (not including the cost of the rings and main/rod bearings). Before-- And after-- __________________ "A CA? WTF is that? You shoulda got an SR yo." View my vBPicGallery!