bushings!

[JDS Performance]

Originally Posted by mello88

My whitelines were weird and they didn't give me good instructions either..

BTW got my subframe bushings done over the weekend too. All you guys screwing around with torchs and sawsalls, you are wasting major time! I think we were all done in an hour or so at the shop using a press. Press out the old bushings, then just hammer in the new (frozen) bushings with a little grease.



Can't wait to get the z32 stuff & arms bolted up... This weekend hope to get it in.

BTW this is a great thread thanks for making/contributing guys..

yeah but not everyone has someone with a shop press - plus they could not press out our front s14 sleeves anyways - somtimes you just gotta bite the bullet and cut them out - its not that bad/hard anyways

[statik]

Originally Posted by JDS Performance

yeah but not everyone has someone with a shop press - plus they could not press out our front s14 sleeves anyways - somtimes you just gotta bite the bullet and cut them out - its not that bad/hard anyways

Agreed, my press was ~$250 and not nearly big enough to do that job, and most people do the solid bushings which you can just hammer in, so no press is required for those.

Glad to see more people replacing these old bushings