300zx Master Cylinder in S14---bending lines. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

The Chad · 01-24-2008, 06:28 AM

Well fine then

, I used a bender to be safe, but i guess it's not necc. I did not use the flare tool though. I used a Dremmel and got out the fitting from the stock BMC and tapped it into the Z32 unit. Took all of 2 mins to cut it out. But that's just what i did. As you can see from the posts, there are a couple diff ways of doing this, So i suppose pick one and good luck!

01-24-2008, 06:28 AM	#1
The Chad Zilvia Addict Join Date: Feb 2007 Location: Richmond, VA Age: 44 Posts: 943 Trader Rating: (0) Feedback Score: 0 reviews	Well fine then , I used a bender to be safe, but i guess it's not necc. I did not use the flare tool though. I used a Dremmel and got out the fitting from the stock BMC and tapped it into the Z32 unit. Took all of 2 mins to cut it out. But that's just what i did. As you can see from the posts, there are a couple diff ways of doing this, So i suppose pick one and good luck!