1jz/2jz swap kit need input - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

ruckus-racing · 01-31-2008, 06:17 AM

the price is not set in stone i have to figure out exactly what has to go into them. you have the remember laser cutting cost,welding time, cleaning, and powder coating. all this adds up at the end of the day.

driftking777 · 01-31-2008, 01:11 PM

i have done the 2jz swap, i personally got all the stuff from tech2, fitment is nice, easy swap, however tech2 seems to be very unorganized, it took me about 2-3 months to get everything i ordered from them (and everything was instock)...and there was alot of "fabbing" required to make stuff fit, which pisses me off after spending 1500 bucks for a "bolt in" kit

however...pics

and for further instructions, i would recommend doing this all with a car lift, because putting the motor in from the top is a PITA...from the bottom is premo.

~Nick

Zilvia4eva · 01-31-2008, 07:40 PM

like I said before $850 is resonable with the drive shaft included....and if the quality is good,you will blow out the competition for that price

these parts shouldn't be any harder to fabricate than the rb25 mounts,only difference is that the rb is much bigger

01-31-2008, 06:17 AM	#1
ruckus-racing Zilvia.net Advertiser Join Date: Nov 2007 Location: dayton ohio Age: 40 Posts: 57 Trader Rating: (0) Feedback Score: 0 reviews	the price is not set in stone i have to figure out exactly what has to go into them. you have the remember laser cutting cost,welding time, cleaning, and powder coating. all this adds up at the end of the day.

01-31-2008, 01:11 PM	#2
driftking777 Zilvia Junkie Join Date: Feb 2005 Location: South Dakota Posts: 554 Trader Rating: (2) Feedback Score: 2 reviews	i have done the 2jz swap, i personally got all the stuff from tech2, fitment is nice, easy swap, however tech2 seems to be very unorganized, it took me about 2-3 months to get everything i ordered from them (and everything was instock)...and there was alot of "fabbing" required to make stuff fit, which pisses me off after spending 1500 bucks for a "bolt in" kit however...pics and for further instructions, i would recommend doing this all with a car lift, because putting the motor in from the top is a PITA...from the bottom is premo. ~Nick

01-31-2008, 07:40 PM	#3
Zilvia4eva Zilvia Junkie Join Date: Apr 2005 Location: dirtysouth Posts: 593 Trader Rating: (0) Feedback Score: 0 reviews	like I said before $850 is resonable with the drive shaft included....and if the quality is good,you will blow out the competition for that price these parts shouldn't be any harder to fabricate than the rb25 mounts,only difference is that the rb is much bigger