drilling hole for crank angle sensor - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

codyace · 05-02-2008, 10:41 PM

Just drill a hole in the right spot, put a washer around the sensor 'pole', and trim the one side so the mounting bolt goes through (washer is to compensate for the raised part on the obdII tranny), and tap the hole for the mount screw.

To easy. Not srue why you guys are turning this into more than it really should be.

I've done 4 or 5 now that way, not a single one has had an issue. Call it lucky, call it what you want, but my way works.

05-02-2008, 10:41 PM	#17
codyace Post Whore! Join Date: Dec 2004 Location: Poconos, PA Age: 40 Posts: 8,030 Trader Rating: (58) Feedback Score: 58 reviews	Just drill a hole in the right spot, put a washer around the sensor 'pole', and trim the one side so the mounting bolt goes through (washer is to compensate for the raised part on the obdII tranny), and tap the hole for the mount screw. To easy. Not srue why you guys are turning this into more than it really should be. I've done 4 or 5 now that way, not a single one has had an issue. Call it lucky, call it what you want, but my way works. __________________ *Want Air Conditioning in your SR20 Swapped car? Check out www.sr20acbrackets.com for more information! Quest Alternator Conversions for SR20!* Check my Group Buy! Tired of lousy internal gates? Go external wastegate with one of my manifolds, Check out my group buy