not going in gear

[Killa_D]

Originally Posted by ocska04

yes i replaced the clutch and throwout bearing and i also have a new nismo slave cylinder. When i try to bleed the clutch it only builds pressure about a 1/4 off the clutch pedal from bottom to top but when i open the bleeder the fluid comes out with pressure and no air in the system. I tried adjusting the rod for the pedal so many times and no solution

ok do you have the stock clutch line system or do you have the line connected straight to the slave cylinder? the same thing happened to me when i installed my throwout bearing backwards easy thing to do when your in a hurry but yeah the car wouldn't go in gear so yeah try that. I would say change your clutch but you did that it couldn't be you slave because its working so the throwout bearing might be installed wrong or the fork is off try to recheck that.

[ocska04]

well i know for a fact that i didnt put the throwout bearing backwards cause i had the tranny out for two weeks and i made sure it was on correctly and as far as the fork goes im sure its on right cause it locked into place with that lil wire lock that it goes onto the pivot ball. Anyone willing to buy this s14 as is for $5500