anyone know of a good write up on hockey puck mounts?

[S14DB]

Originally Posted by Verbal_S13

Sorry but, your an idiot and your logic is proof. They are discs of vulcanized rubber. They give a little under load and are rock solid. Much better than filling a rubber mount with (i think he said polyurethane), that is ghetto.

The rubber tears at the bolt and comes apart after a couple of months.

[Verbal_S13]

Originally Posted by S14DB

The rubber tears at the bolt and comes apart after a couple of months.

Um..BS. I have used them in several setups (On and Off road) and have never had one tear.... and i have been using them for quite a while.
I just finished an sc300 with a hx40....and he "chose" hockey pucks.

I drill them a bit smaller than the size of the sleeve, then heat the sleeve and press it into the puck. Voila! You can also make spacers out of aluminum to place in between the pucks to keep your pinion angles in check.


.....but don't take my word on it, I'm a noob.