Clutchswap WHAT THE FUCK

[Fries]

Originally Posted by zugoi

good man. Do it right the first time. New one is couple bucks. Not worth pulling tranny out again. Be sure to use the ratchet end of the socket to tap it in to prevent mushrooming so what happened to me doesnt happen to you. Also lube all parts that will be sliding or contacting each other so it will slide easier but be sure none of the grease will touch the clutch disc flywheel pressure plate etc. Good luck

I ordered the NISMO one, because well... it looked cool.

I'll be using something rubber based to put this one in so I dont mushroom shit.

P.s. Can anyone recommend me a pilot bearing puller tool that will fit in our cars? Min spread seems to be 1/2 inch which I think is cutting a little close.

How big is the hole in the bearing?

[Om1kron]

Originally Posted by Fries

I ordered the NISMO one, because well... it looked cool.

I'll be using something rubber based to put this one in so I dont mushroom shit.

P.s. Can anyone recommend me a pilot bearing puller tool that will fit in our cars? Min spread seems to be 1/2 inch which I think is cutting a little close.

How big is the hole in the bearing?

pilot bearing differences.
Bearing Briefing on Vimeo

pilot bearing removal
Pilot Bearing Removal on Vimeo