Factory hollow rear sway bars that fit on S chassis - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

racepar1 · 08-04-2009, 08:57 AM

I looked under the z, but unfortuanetly I can't put it up in the air since it's not at our shop. It looks like the z-33 rear sway is about 22-23 mm thick, definitely hollow, and will most likely clear the s-chasis exhaust. I don't think the dimensions will work though. The z-33 rear bar steps back (towards the diff) through the center of the bar. It bends just inside the bushings and steps back a good 2-3" and it also looks to step down 1-2".

08-04-2009, 08:57 AM	#28
racepar1 Post Whore! Join Date: Jul 2007 Location: Simi Valley, CA Age: 42 Posts: 9,006 Trader Rating: (106) Rides Gallery: racepar1 Feedback Score: 106 reviews	I looked under the z, but unfortuanetly I can't put it up in the air since it's not at our shop. It looks like the z-33 rear sway is about 22-23 mm thick, definitely hollow, and will most likely clear the s-chasis exhaust. I don't think the dimensions will work though. The z-33 rear bar steps back (towards the diff) through the center of the bar. It bends just inside the bushings and steps back a good 2-3" and it also looks to step down 1-2".