GT2871 USERS. SR motor

[slider2828]

1st off are yo really going to run this setup with an AFC? Really? That is totally not recommended especially with injectors this siz. I would suggest do some research... Don't bother.... I pull about 8PSI which is about 16kg/mm or something like that.... I use lines and why is the coolant ran to the back of the motor and not into the block like stock? Is this a KA? Also secondly, did you put a oil restrictor on it as most new oil lines don't have restrictor...

Finally did you read ANY pages on this thread?

[jspaeth]

Originally Posted by slider2828

1st off are yo really going to run this setup with an AFC? Really? That is totally not recommended especially with injectors this siz. I would suggest do some research... Don't bother.... I pull about 8PSI which is about 16kg/mm or something like that.... I use lines and why is the coolant ran to the back of the motor and not into the block like stock? Is this a KA? Also secondly, did you put a oil restrictor on it as most new oil lines don't have restrictor...

Finally did you read ANY pages on this thread?

I could be wrong, but I think the person asking the question is right....the stock water line runs to the back of the block.

What many people do is to block that off with a bolt and a hose clamp....get an S14 water neck (up near the front right of the head...tap into that and run your water to there.

Wayyyy easier that way.

[slider2828]

Originally Posted by jspaeth

I could be wrong, but I think the person asking the question is right....the stock water line runs to the back of the block.

What many people do is to block that off with a bolt and a hose clamp....get an S14 water neck (up near the front right of the head...tap into that and run your water to there.

Wayyyy easier that way.

Oooooo yeah its that 3rd line... I totally forgot lol..... Hmmm my taka lines were SUPER long from what I remember and I didn't have a problem....