rb25det thermostat

[Z U L8R]

doesn't matter, fit is the same, same exact part. no modification required.

get a t stat for a 93 300zx TT and it's the same as your rb20, rb25, rb26, old, shneo, or whatever. make sure you install it correctly and with the bleeder wobbly deelio at the top. and when you're adding coolant take the bleeder screw out of the intake manifold (10mm) so it fills all the way up with little air pockets.

Dave

[thrasher324]

Originally Posted by Z U L8R

doesn't matter, fit is the same, same exact part. no modification required.

get a t stat for a 93 300zx TT and it's the same as your rb20, rb25, rb26, old, shneo, or whatever. make sure you install it correctly and with the bleeder wobbly deelio at the top. and when you're adding coolant take the bleeder screw out of the intake manifold (10mm) so it fills all the way up with little air pockets.

Dave

can you tell me where the bleeding screw is? ive been trying to look for it but idk where the hell it is

[eklips3]

Originally Posted by thrasher324

can you tell me where the bleeding screw is? ive been trying to look for it but idk where the hell it is

follow the upper rad hose to where it goes into your intake manifold.
look for the little clip that has one wire coming out of it(its one of the 2 sensors there). that is the sensor that sends signal to the coolant temp guage on your dash. anyways i used that as my bleeder ... works the same.