CA Z32TT front brake calipers, many other upgrade and OEM parts. Stillen, FMIC, Methanol - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

KevinZtwin · 05-15-2010, 03:49 PM

I have some parts that I would like to clear out of my garage and in the process get more funds to buy other upgrades. All prices are before shipping, add 3% if using paypal. Local Socal people can arrange a pickup if needed and some I might be able to deliver for.

Snow Performance Methanol Injection Kit (stage 2): $450 for everything with all the extras/upgrades
- Upgraded 220psi Pump (150psi is the regular one)
- Upgraded solenoid (new, never installed, Cost $50) PN# 40060
- 375mL nozzles (x2)
- Variable injection controller (gradually increases injection from 8psi all the way up to 25psi)
- Safety Injection Module (in case you run out of fluid or for some reason have an interruption in methanol injection it will lower your boost or retard your timing to save your motor) - Cost $159
- Hardpipes with bungs welded on (you need couplers and clamps)
- No tank, the windshield washer fluid tank was used utilizing the low level indicator light
- All manuals, everything needed to install

　
Stock Tail Lights (all three pieces) in excellent condition. I have some leftover sealant, but you will probably need more. Sorry for the dust: $100

I have 2 of these leftover rolls of the weather sealant

OEM 1990TT Rear Traction Rods: $15 each

STILLEN Front Crossdrilled rotors (11"x30mm): SOLD

STILLEN Front Tension Rods (adjusts Caster). I had an alignment shop say they could not get one of them loose to adjust it, so I got a new set. If you can get it loose they will work fine, or just leave them in the current position which should be okay: SOLD

1990TT OEM front 30mm calipers with Stillen metal matrix pads with some life left in the pads: SOLD

AMS 3” Expansion Down pipes (5 bolt) with O2 bungs (new, never installed): $300

AMS TT Exhaust Manifolds (new, never installed): $450

OEM TT Precats/downpipes: $60

OEM Rear suspension dampening adjusters: $10/pair

OEM shift knob: SOLD

SS Braided brake lines: SOLD
Sway bar end links (front OEM, rear Stillen): $30

CX Racing FMIC 3” Core with couplers, piping, and T-Clamps (prefer local pickup or I can deliver for some people), new, never installed: $300

OEM TT SMICs - $60/pair

OEM TT HICAS Actuator - $50
OEM TT HICAS Rack - $60

Tokico HP shocks with Eibach Prokit Springs (approx. 25k miles) - $250
One of the mounting studs on the rear is a little larger, you will either need a 14mm nut or swap in a 12mm stud/nut like the rest of them. I am assuming the installer snapped a stud and used what he had laying around. Dust boots are shot from being in a really hot/dry climate. No problems with them, just upgraded to coilovers.

Prefer PM or email
[email protected]

Located in Palm Desert, CA. But I make trips to the Long Beach area almost every week if you need delivery.

Kevin

mojos13 · 05-15-2010, 04:38 PM

Z32 front calippers & stillen tension rods, PM sent!

KevinZtwin · 05-15-2010, 10:48 PM

Z32 Calipers SOLD
Stillen Rotors: SOLD

Alan_G · 05-16-2010, 12:14 PM

will the rotors only fit on z32 calipers?

KevinZtwin · 05-16-2010, 09:31 PM

Z32TT: Front Calipers: SOLD
Stillen Tension Rods: SOLD
Stillen Brake Rotors: SOLD
Shift Knob: SOLD

Everything else: Available

KevinZtwin · 05-17-2010, 10:21 PM

Brake lines sold

*racerx2k1* · 05-18-2010, 07:51 AM

Quote:

Originally Posted by KevinZtwin

Z32 Calipers SOLD
Stillen Rotors: SOLD

Quote:

Originally Posted by KevinZtwin

Z32TT: Front Calipers: SOLD
Stillen Tension Rods: SOLD
Stillen Brake Rotors: SOLD
Shift Knob: SOLD

Everything else: Available

Quote:

Originally Posted by KevinZtwin

Brake lines sold

2 bump limit. You can start new thread in 3 days.

05-15-2010, 03:49 PM	#1
KevinZtwin Join Date: Feb 2009 Location: Long Beach, CA Age: 38 Posts: 23 Trader Rating: (0) Feedback Score: 0 reviews	Z32TT front brake calipers, many other upgrade and OEM parts. Stillen, FMIC, Methanol I have some parts that I would like to clear out of my garage and in the process get more funds to buy other upgrades. All prices are before shipping, add 3% if using paypal. Local Socal people can arrange a pickup if needed and some I might be able to deliver for. Snow Performance Methanol Injection Kit (stage 2): $450 for everything with all the extras/upgrades - Upgraded 220psi Pump (150psi is the regular one) - Upgraded solenoid (new, never installed, Cost $50) PN# 40060 - 375mL nozzles (x2) - Variable injection controller (gradually increases injection from 8psi all the way up to 25psi) - Safety Injection Module (in case you run out of fluid or for some reason have an interruption in methanol injection it will lower your boost or retard your timing to save your motor) - Cost $159 - Hardpipes with bungs welded on (you need couplers and clamps) - No tank, the windshield washer fluid tank was used utilizing the low level indicator light - All manuals, everything needed to install 　 Stock Tail Lights (all three pieces) in excellent condition. I have some leftover sealant, but you will probably need more. Sorry for the dust: $100 I have 2 of these leftover rolls of the weather sealant OEM 1990TT Rear Traction Rods: $15 each STILLEN Front Crossdrilled rotors (11"x30mm): SOLD STILLEN Front Tension Rods (adjusts Caster). I had an alignment shop say they could not get one of them loose to adjust it, so I got a new set. If you can get it loose they will work fine, or just leave them in the current position which should be okay: SOLD 1990TT OEM front 30mm calipers with Stillen metal matrix pads with some life left in the pads: SOLD AMS 3” Expansion Down pipes (5 bolt) with O2 bungs (new, never installed): $300 AMS TT Exhaust Manifolds (new, never installed): $450 OEM TT Precats/downpipes: $60 OEM Rear suspension dampening adjusters: $10/pair OEM shift knob: SOLD SS Braided brake lines: SOLD Sway bar end links (front OEM, rear Stillen): $30 CX Racing FMIC 3” Core with couplers, piping, and T-Clamps (prefer local pickup or I can deliver for some people), new, never installed: $300 OEM TT SMICs - $60/pair OEM TT HICAS Actuator - $50 OEM TT HICAS Rack - $60 Tokico HP shocks with Eibach Prokit Springs (approx. 25k miles) - $250 One of the mounting studs on the rear is a little larger, you will either need a 14mm nut or swap in a 12mm stud/nut like the rest of them. I am assuming the installer snapped a stud and used what he had laying around. Dust boots are shot from being in a really hot/dry climate. No problems with them, just upgraded to coilovers. Prefer PM or email [email protected] Located in Palm Desert, CA. But I make trips to the Long Beach area almost every week if you need delivery. Kevin Last edited by KevinZtwin; 05-17-2010 at 10:15 PM..

05-15-2010, 10:48 PM	#3
KevinZtwin Join Date: Feb 2009 Location: Long Beach, CA Age: 38 Posts: 23 Trader Rating: (0) Feedback Score: 0 reviews	Z32 Calipers SOLD Stillen Rotors: SOLD Last edited by KevinZtwin; 05-16-2010 at 09:28 PM..

05-16-2010, 09:31 PM	#5
KevinZtwin Join Date: Feb 2009 Location: Long Beach, CA Age: 38 Posts: 23 Trader Rating: (0) Feedback Score: 0 reviews	Z32TT: Front Calipers: SOLD Stillen Tension Rods: SOLD Stillen Brake Rotors: SOLD Shift Knob: SOLD Everything else: Available Last edited by KevinZtwin; 05-17-2010 at 12:08 AM..

05-15-2010, 04:38 PM	#2
mojos13 Zilvia Member Join Date: Apr 2007 Location: miami Posts: 180 Trader Rating: (16) Feedback Score: 16 reviews	Z32 front calippers & stillen tension rods, PM sent!

05-16-2010, 12:14 PM	#4
Alan_G Join Date: May 2009 Location: CA Posts: 40 Trader Rating: (2) Feedback Score: 2 reviews	will the rotors only fit on z32 calipers?

05-17-2010, 10:21 PM	#6
KevinZtwin Join Date: Feb 2009 Location: Long Beach, CA Age: 38 Posts: 23 Trader Rating: (0) Feedback Score: 0 reviews	Brake lines sold