DIF Controller Melting Inline Power Fuse

[LayNLow]

I have the same problem, but I am running 2 altima fans that are wired to run on high. I assume it does this when both of them run at the same time because it doesnt normally do it until I start to really heat the engine up. I am not sure if the DIF controller will be able to handle upgraded power/fuse wiring, it is something I have always wondered about.

[Sileighty_85]

Originally Posted by LayNLow

I have the same problem, but I am running 2 altima fans that are wired to run on high. I assume it does this when both of them run at the same time because it doesnt normally do it until I start to really heat the engine up. I am not sure if the DIF controller will be able to handle upgraded power/fuse wiring, it is something I have always wondered about.

You should find out as well how much AMPS those fans pull.

Upgrading the wires is not a problem at all, a rule of thumb with wiring is when replacing "always use the same size or bigger wiring", never use smaller.

Fuses are a different story always use the exact fuse never use a bigger fuse.