Can i use s13 aem ems on s14 sr20det??

[Darren]

Originally Posted by Humanblob

Lol you could sell it to me and use the money to buy one for a s14

THis is probably your best bet, just sell it to someone with a S13 SR20 (i wish i had the money right now) and buy another one specifically for the s14 sr20.

I think some of the sensors might be different too? someone correct me if i'm wrong on this...

[GSXRJJordan]

Originally Posted by Darren

THis is probably your best bet, just sell it to someone with a S13 SR20 (i wish i had the money right now) and buy another one specifically for the s14 sr20.

I think some of the sensors might be different too? someone correct me if i'm wrong on this...

No, the sensors are not different. Some pin locations may be different, depending on which part numbers, but if the ECU connectors are physically compatible, everything else is gravy.

[steve shadows]

Originally Posted by GSXRJJordan

No, the sensors are not different. Some pin locations may be different, depending on which part numbers, but if the ECU connectors are physically compatible, everything else is gravy.

Jordan is pretty much correct on this one.

There are a few pins that are moved around and a few things that will be missing on the S13 EMS. Remember the S14 motor is VTC so there needs to be an output to switch the VTC solenoid. It should be possible to configure one of the outputs on the EMS through the AEM software to perform the duty of switching the VTC over. I would contact AEM though to get a for sure explanation of the differences but I am pretty sure that's the only major bump in the road for using it (pinout location and vtc setup). cheers

[GSXRJJordan]

Originally Posted by steve shadows

Jordan is pretty much correct on this one.

There are a few pins that are moved around and a few things that will be missing on the S13 EMS. Remember the S14 motor is VTC so there needs to be an output to switch the VTC solenoid. It should be possible to configure one of the outputs on the EMS through the AEM software to perform the duty of switching the VTC over. I would contact AEM though to get a for sure explanation of the differences but I am pretty sure that's the only major bump in the road for using it (pinout location and vtc setup). cheers

Good to see you still on here Steve!

Yup, software's the same, so when you load the S14 calibration it'll have VTC set on one of the low side outputs. It's easy to change to whatever low output you want.