*Ask Broadfield*

[Broadfield]

Originally Posted by lalo167

Its cracked on two corners. Bought a new dash and dont want to have the ugly hole. I want to keep the HUD trim.

You will need to glue it really well, sand down any extra glue that squeezed out the front and then re-texture the whole thing. Feel free to post a pic of the damage so I can make sure my recommendation is the best solution. After you post a pic then I'll recommend the best glue and process for the job.

Or I'm pretty sure I have a mint HUD trim that I could sell you.

[lalo167]

Originally Posted by Broadfield

Or I'm pretty sure I have a mint HUD trim that I could sell you.

PM me the price shipped to 90670?

[Broadfield]

Originally Posted by lalo167

PM me the price shipped to 90670?

I have to find it first.

Originally Posted by Lil_D

my sr was idling earlier yesterday in my garage because i was looking for vacuum leaks. well while idling a puff of smoke came out of my engine bay on the exhaust side. i immediately turned the car off and looked at where the smoke might have come from and i couldnt find it. well i went to start the motor again to see if it would happen again. while i was cranking the motor over it locked up on me. why do you think it locked up? i need help so i can get my car on the street

I'm not an engine guru... there are plenty of guys on here that are much more qualified to answer that question.

Originally Posted by sidewayzsilvia

Just sent my z32 calipers out for powder coating. I saw you post on the powder coat color thread and wanted to know if you had a write up on zinc plating the hardware, or maybe just a materials list of what was used. Definitely wanna try this.

I do not have a write-up. If you buy a zinc plating kit then it will have instructions with it. This is where I put my kit together from:

Plating Kits Electroplating Kits Aluminum Anodizing Kits Powder Coating Systems Metal Polishing And Buffing Supplies - Caswell Inc

Originally Posted by 3ternal

Just installed my 4 channel MB Quart Fx4.100 amp, and when I go to test the rear speakers which are connected to ch. 3 & 4, I immediately get cracking and static. This happens even when my head unit is off too.

Any suggestions?

I'm not sure if you figured this out yet or not, but have you tried the RCA's from channels 1&2 to see if you still have the noise? Have you tried putting the speakers from channels 1&2 on channels 3&4? If the noise goes away then you know it's something with the speakers or speaker wire. Have you simply tried a test speaker at the amplifier on channels 3&4?

Originally Posted by lewisfk

Broad. are you familiar with the Pioneer shallow 10 inch subs? The reason I ask is because I went to check out the West Coast Customs shop located on Camp Pendleton. I meet the head install guy and he stated the pioneer subs sound better than the JL TW13. I say bullshit but I have no friends pushing the sub. Any personal pref. between the two?

I do not with the 10's, but I have done the 12's... and they do not compare to the JL's