(*)(*)sr20det help!!(*)(*)

[ReLiC]

did you figure it out? i'm trying to wire mine up as well.

Where are you grabbing the 12v from? Is it ok to just grab it from the maf power?

[OutlawLui]

Originally Posted by ReLiC

did you figure it out? i'm trying to wire mine up as well.

Where are you grabbing the 12v from? Is it ok to just grab it from the maf power?

Yea the pic is correct

On the red top sr its

harness------skinny o2

Brown--------red
White---------black
Black---------white


The brown harness wire is the 12v sourse

*on the skinny o2 sensor the black wire is the signal wire and white is ground

[Kingtal0n]

heres what I usually do. Go to pep boys and look through the oxygen sensor boxes until you find all the 1-wire oxygen sensors. Buy the cheapest one, usually $12 or $14.

Now, you know exactly which wire is the signal since there is only 1 wire. Install using the single signal wire and never worry about this again. If you put a voltmeter on the wire, it will flip from 0.005Volt - 0.985+Volt when working properly.

[OutlawLui]

Originally Posted by Kingtal0n

heres what I usually do. Go to pep boys and look through the oxygen sensor boxes until you find all the 1-wire oxygen sensors. Buy the cheapest one, usually $12 or $14.

Now, you know exactly which wire is the signal since there is only 1 wire. Install using the single signal wire and never worry about this again. If you put a voltmeter on the wire, it will flip from 0.005Volt - 0.985+Volt when working properly.

Im pretty sure pepboys doesn't have a large selection of titania o2's