Wheel Fitment Question Thread

[Khoda]

I need some input with fitment/ wide body on my s13. I am looking for the stretch poke fitment. Below are my specs as of now. I am looking for another set of tires for more of a stretch with keeping it safe as a DD. Car is going in for paint so want to have the fitment perfect for when the kit is installed. Still need to cut the rear fenders above the body line, if anyone can do a quick line of how high I can cut side to side and up that would be great!



Front

Fender: 30mm

Rim: 18x11

Et: -1 with 10mm spacer ( final et -11 need spacers to clear 300zx brakes)

Tire: 245/35

Camber: -4 ( can't go more unless I still the coil for camber)



Rear

Fender: 50mm

Rim:18x12.5

Et: -18 ( with 4mm spacers final -22)

Tire: 285/30

Camber: -1.5 ( can't go more)





Thank you for your help!


Sent from my iPhone using Tapatalk

[revat619]

Originally Posted by Khoda

I need some input with fitment/ wide body on my s13. I am looking for the stretch poke fitment. Below are my specs as of now. I am looking for another set of tires for more of a stretch with keeping it safe as a DD. Car is going in for paint so want to have the fitment perfect for when the kit is installed. Still need to cut the rear fenders above the body line, if anyone can do a quick line of how high I can cut side to side and up that would be great!



Front

Fender: 30mm

Rim: 18x11

Et: -1 with 10mm spacer ( final et -11 need spacers to clear 300zx brakes)

Tire: 245/35

Camber: -4 ( can't go more unless I still the coil for camber)



Rear

Fender: 50mm

Rim:18x12.5

Et: -18 ( with 4mm spacers final -22)

Tire: 285/30

Camber: -1.5 ( can't go more)





Thank you for your help!


Sent from my iPhone using Tapatalk

I hope your front fenders are tubbed with that size up front. As far as where to cut on the rear quarter panel, it's just above the body line in an arch like the original fender. There's videos of it all over youtube. Its kinda hard to explain in text.

[Khoda]

Originally Posted by revat619

I hope your front fenders are tubbed with that size up front. As far as where to cut on the rear quarter panel, it's just above the body line in an arch like the original fender. There's videos of it all over youtube. Its kinda hard to explain in text.

Front is not tubbed. I was going to, ( still am) BUT it is not needed for some reason. I hammered them in a little and I can make full lock turns it is a tight fit. And I am going to tubb them when I pull the motor out. But as of now it's okay.

And thanks! I'll look on YouTube.


Sent from my iPhone using Tapatalk

[Tora S13]

Hey would a 17x8 +38 rim with 235/45/17 tires all round work on a 89 240sx without spacers, pulling? Gonna eventually get flares/overfemders, but would this setup work with un rolled, pulled, etc fenders? Thanks!