|
I had a full 8pt bent up by ca chassis works, but I only did the hoop and rear support bars making it a roll bar. I was too lazy to put the rest in. I took all the measurements and they bent it up for me. I've still got the spec sheet, I can send it to someone if they want to have them bend one up for them. I had the front A pillar bars bent to go through the dash air vents too, it would've been sweet. All their stuff is mandrel bent too, so it's REALLY strong. They won't install it in your car for you though. The only people who should think about having them do it are those of you with fabrication skills and tools. grinders, chop saws, welders etc.
__________________
|
10-14-2004, 12:05 PM
Hybrid Mode
