Deaf Drifter 240sx Build

[dbeiler]

Looking good! What tie rod setup will you be using with those PBM knuckles?

[PIN GIO 2]

Originally Posted by dbeiler

Looking good! What tie rod setup will you be using with those PBM knuckles?

to be honest, i still learning and noob how to set up front suspension super angle.

I plan to order VooDoo13’s S13 Front Adjustable Tension Rods, i hope my front suspension are great increased steering angle.

Front Lower Control Arm modded extended 25mm and gussted. The ball joint replaced Moog ball joint but it isn't tight as sitting on it im not sure how to explain like you know when you installed ball joint but it still loose around 2-3mm gap, is that ok? I will add mod adjustable lock stop next week. i still not sure about mod scalloped lower arm for allow knuckle to more travel because of PBM knuckle 45 of correction.

I think about keep tein tie rod inner/outer and i already put GKtechs spacing the tie rods farther forward on it.

You can see my front suspension setup kind of issue with SIkky sway bar clearance between rim but i haven't install sway bar so i believe do i need mod sway bar cut more short and weld it?

I hope you guys can help or correct me whatever i doing wrong.