input shaft bearing replacement

[NemeGuero]

Originally Posted by max_misawa

press the pedal all the way to the floor
while the car is running
if there is noise it is inside the transmission

Max

Good job adding NOTHING to the post.

I have the same whine, think its the same bearing. Does the FSM outline the process at all? I was in the market for a new tranny 'cuz I didn't think it was something I had the tools for..

[max_misawa]

Originally Posted by NemeGuero

Good job adding NOTHING to the post.

I have the same whine, think its the same bearing. Does the FSM outline the process at all? I was in the market for a new tranny 'cuz I didn't think it was something I had the tools for..

the OP said clutch engauged
which means there is no pressure on the pedal
you might want to get off the high horse of yours

you have to depress the pedal all the way to the floor to release the transmission, granted that the hydrolics are working properly

i mean it would suck to take the transmission out and apart to buy 100 dollar bearing?
just to find out it was just the TO or pilot which is a 20 dollar fix

Max