hello, front clip arrives tomorrow morning, this is my first motor swap and i'm kinda assuming i'll be able to remove everything from the clip and figure out where it goes on the 240. I have a few questions, i search and read but asking questions in a thread is simpler than searching. so...
I'm not sure how to deal with wiring, specifically the RHD jdm harness with the LDH and usdm firewall. Also If i'm gonna run Apexi Power FC D-jet in a few months how to wire things for that to work also. Do i have to cut a passage in the firewall for the JDM harness to reach the left hand drive, or extend the wires...is there any harness job or whatever lightening that works properly with the d-jetro. basically not sure about the harness situation, i'd like the cleanest setup capable with the apexi.
I guess thats all i'm wondering at the moment, I'll probably have a few other questions for a few days during the swap. I'm going for a completely stock install since i cant afford parts(injectors, management, toda flywheel/clutch, guages, radiator, ect...) at the moment. thank you for your time
john
07-11-2007, 10:50 AM
Threaded Mode