installing transmission...less than 1 inch close - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

onehalfasia · 09-06-2007, 09:16 PM

working on the transmission install, so close but wont go, is it lined up if its that close or do i have to adjust the angle for the final inch. feels like when i try to install it(shaft part) goes up a small lip, then when removing 1mm or so out it slips down off the lip, thats from the 1mm of in/out play, any advice appreciated. transmission rotates freely and is supported by a few jacks.

09-06-2007, 09:16 PM	#1
onehalfasia Zilvia Member Join Date: Mar 2005 Location: SPOKANE Posts: 238 Trader Rating: (0) Feedback Score: 0 reviews	installing transmission...less than 1 inch close working on the transmission install, so close but wont go, is it lined up if its that close or do i have to adjust the angle for the final inch. feels like when i try to install it(shaft part) goes up a small lip, then when removing 1mm or so out it slips down off the lip, thats from the 1mm of in/out play, any advice appreciated. transmission rotates freely and is supported by a few jacks.