Car wont start... S13sr in S14

[Om1kron]

cliffs.
coil pack sub harness was pinned incorrectly, therefore causing 1 and 3 to get hot when trying to turn over. Re-pinned it following the ignition chip, still wont start.

So... I will update my build thread in a bit. Here is my dillema...

car cranks
is getting fuel
i'm getting spark

there is probably something else I should say that makes me sound smart, but i'll leave that.

Only thing that is not grounded is the alternator, so the battery is not going to get charged. I have a battery charger hooked up to the battery so it doesn't drain trying to start the car. So power is there.

Here is my current pinout.

From the engine harness.

Male Plug
1. L/R
2. R/G
3. R
4. nothing
5. R/W
6. R/L

From the sub harness.

Female plug
1. R
2. R/G
3. B/Y
4. B
5. R/W
6. nothing

I think something is mixed up here =(

halp I cannot find a pin out for these two things and it's an S13 SR. Someone please take a picture of their pin out and write down your wire order for me... (cough jeff jordan.)