*Ask Broadfield*

[ZERTA RACING]

Toby,
Sorry to bother you on a sunday but I have a few questions. I bought a Viper system from you a few pages back and I finally have the time to get to work on it. I have labeled every wire so I can tie them all and know exactly where they go before the install. My questions are about the 530T and the relay for power locks and a few little wires I am having trouble finding where they go.

My final setup will be:
Viper 5904V
VSM250 GPS SmartStart
tilt sensor (507M)
door locks (451m with 524N)
window roll-up modules(530T)
trunk release(522T with relay)

First off I found this on the thread you referred me to and want to ask if these were the proper connections and if a bypass was necessary

530T Window Automation Module Wiring

H1/1 Violet- ground path motor #1 --> chassis ground
H1/2 Green- driver’s side down motor (motor side) --> driver side door blue (motor side)
H1/3 Blue- up, motor (motor side) --> driver side door green (motor side)
H1/4 Red- Constant 12V --> from battery or white at ignition harness
H1/5 Black- chassis ground --> chassis ground
H1/6 Violet/Black- ground path motor #2 --> chassis ground
H1/7 Green/Black- passenger side, down motor #2 --> passenger side door blue or red/white (motor side)?
H1/8 Blue/Black- up, motor #2 passenger side --> passenger side door green or red/black (motor side)?

H2/1 Brown- up, switch #1 (switch side) --> drivers side door green (switch side)
H2/2 White- driver side down switch #1 (switch side) --> drivers side door blue (switch side)
H2/3 Red/White (-) - auxiliary input --> connects to H2/6 white/violet on alarm
H2/4 Orange (-) - ground when armed --> connects to H1/12 orange on main alarm harness
H2/5 Grey- output during activation --> wires to relay to bypass audio, motion and tilt sensors (see relay connections below)
H2/6 Brown/Black- up, switch #2 passenger side (switch side) --> passenger side door green or red/black (switch side)?
H2/7 White/Black- down, switch #2 passenger side (switch side) --> passenger side door blue or red/white (switch side)?

Sensor Bypass Relay

85- H2/5 Grey from 530T
86- 12V (fused) from battery
87- N/A
87A- Red wire from tilt, audio and motion sensor
30- Red wire from alarm

Next is the Violet/Blk fused on the 451m where does that go?

The Blue/white on the Viper 5904V for remote start/turbo timer is that used with the smart start or just not used at all.

Also the green on the shock sensor (-) warn output where does that connect to the H2/8 Brown/Black (-) 200ma horn honk?

And lastly on the smart start itself
Grey and white wires are not used
blue/white goes to remote start on viper blue white? Guess that kind of answers one of the questions above lol.
brown to where ?(I don't have a factory alarm)
green (-) to Door lock 3 pin connector Green just spliced in?
Blue (-) to Door lock 3 pin connector Blue just spliced in?
Red/White to (-) H2/5 red/white 200ma trunk release?


Once again sorry for all the questions just want to make sure I get this right and some of the info in that thread is pretty old and the wiring harnesses have changed since then.

-Thomas